The Chilton 1997-2000 Buick Century, Regal; Chevrolet Lumina, Monte Carlo; Olds Cutlass Supreme, Intrigue; Pontiac Grand Prix repair and service manual, covers:
Book Excerpt: 1997-2000 Buick Century, Regal, Chevy Lumina, etc. Repair Manual ENGINE AND ENGINE OVERHAUL
SUSPENSION AND STEERING
Subject: 1997, 1998, 1999, 2000 Buick Century, Regal; Chevrolet Lumina, Monte Carlo; Olds Cutlass Supreme, Intrigue; Pontiac Grand Prix service, maintenance, repair. ISBN-10: 0801993172 | ISBN-13: 9780801993176 | Chilton 28380
- Buick: Century and Regal
- Chevrolet: Lumina and Monte Carlo
- Oldsmobile: Cutlass Supreme and Intrigue
- Pontiac: Grand Prix
Book Excerpt: 1997-2000 Buick Century, Regal, Chevy Lumina, etc. Repair Manual ENGINE AND ENGINE OVERHAUL
EXHAUST MANIFOLD | REMOVAL AND INSTALLATION 3.1L AND 3.4L (VIN E) ENGINES LEFT SIDE (FRONT) (See Figure 48)
- Disconnect the negative battery cable.
- Remove the air cleaner duct.
- Drain the coolant into a suitable container.
- Remove the right side engine mount strut bracket.
- Disconnect the upper radiator hose from the engine.
- Remove the automatic transaxle vacuum modulator pipe.
- Remove the thermostat bypass pipe.
- Remove the exhaust crossover pipe heat shield and then remove the crossover pipe.
- Remove the left side (front) exhaust manifold heat shield bolts and remove the heat shield.
- Remove the manifold bolts and nuts and remove the manifold. Discard the gasket.
TO INSTALL- Clean all parts well. Clean the manifold and cylinder head sealing surfaces.
- Using a new gasket, position the exhaust manifold to the cylinder head. Install the bolts and nuts. Torque to 12 ft.lbs. (16 Nm).
- Install the remaining components in the reverse order of the removal process.
RIGHT SIDE (REAR) (See Figure 49)
- Disconnect the negative battery cable.
- Remove the air cleaner duct.
- Drain the coolant.
- Disconnect the upper radiator hose from the engine.
- Remove the upper radiator hose from the engine.
- Remove the automatic transaxle vacuum modulator pipe.
- Remove the exhaust crossover pipe heat shield and then remove the crossover pipe.
- Detach the oxygen sensor electrical connector.
- Raise and safely support the vehicle.
SUSPENSION AND STEERING
REAR HUB AND BEARING The wheel bearings in the rear wheel hubs are integrated into one unit. The hub is non-serviceable. If the bearing is considered worn out or if the hub is damaged, the complete unit must be replaced. REMOVAL AND INSTALLATION
(See Figure 42)
- Raise and safely support the vehicle.
- Remove the wheel and tire assembly.
- Remove the rear caliper and bracket. Please see Section 9.
- Disconnect the ABS harness and detach the electrical connector.
- Remove the four rear hub-to-knuckle bolts.
- Separate the hub from the knuckle.
Subject: 1997, 1998, 1999, 2000 Buick Century, Regal; Chevrolet Lumina, Monte Carlo; Olds Cutlass Supreme, Intrigue; Pontiac Grand Prix service, maintenance, repair. ISBN-10: 0801993172 | ISBN-13: 9780801993176 | Chilton 28380
TABLE of CONTENTS:
- Introduction: Vehicle identification numbers. Buying parts. Safety. Maintenance techniques. Chemical and lubricants, and more.
- Tune-up and routine maintenance
- General engine overhaul procedures
- Cooling, heating and air-conditioning systems
- Fuel and exhaust systems
- Engine electrical systems
- Emissions control systems
- Manual transaxle
- Automatic transaxle
- Clutch and driveline
- Brakes
- Suspension and steering systems
- Body
- Chassis electrical system
- Wiring diagrams